Print
Hits: 23258
HP

Huff Puff calibration

The Huff Puff method of frequency calibration in the U3 was originally introduced to deal with the poor jitter performance of Sirf III chipset based GPS modules. However it is capable of improving calibration performance with any GPS module. The description applies to the U3 (AD9850 DDS with 125MHz reference oscillator) but is also applicable to the U3S (using Si5351A synthesiser, 27MHz reference oscillator).

Read more...

Spectrum analyser tests

Spectrum Analyser tests

Here are some spectrum analyser testing results, showing harmonic levels, LPF performance, and power output of the U3 kit. The U3S will be slightly different but you can assume broadly similar results apply, particularly the LPF curves are the same.

Read more...

DDS alignment

DDS module testing [U3 only]

Prior to the development of the Si5351A synthesiser module kit used in the U3S kit, the U3 kit used the pre-built AD9850 DDS module. All modules were tested and aligned prior to shipment. This page documents the procedure used, and may be useful if you need to re-align your DDS module for any reason.

Read more...

GPS compatibility notes

GPS compatibility notes

The Ultimate series of QRSS/WSPR kits are optionally able to use a GPS receiver for frequency calibration, time setting, location information, and timekeeping purposes. GPS modules vary and this page lists some common GPS modules known to work well with the kits, and any specific connection details required.

Read more...

KK4YEL Hell

U3 Slow-Hell settings

This page is about the configuration settings in the Ultimate3/3S for slow-Hellschreiber mode ("slow Hell"). It's a tricky topic and had caused some confusion. So this page attempts to explain the settings, their interpretation, and relation to each other.

Read more...

PA bias

U3S PA Bias study

Dave G3WUN wrote with some observations about the bias setting in the U3S PA. By backing off the bias a little, the harmonic levels were significantly lower than when set for maximum power output. This experiment repeats Dave's work and extends it, across multiple bands and more analysis.

Read more...

Bifilar/trifilar PA output

Bifilar/trifilar U3S PA Output

Replacing L1 (25 turns FT37-43 toroid) with a bifilar output transformer (10 turns FT37-43 toroid) seems to significantly increase the power output. This article documents a set of measurements of power outputs using bifilar and trifilar output transformers.

Read more...

ZL2IK U3S

High precision OCXO U3S by Pete ZL2IK

Obtaining really excellent frequency stability results with a U3S and OCXO Synth requires attention to several details (proper OCXO adjustment, thermal considerations, power supplies). This article provides more information and Pete ZL2IK describes his U3S assembly and power regulation. 

Read more...

DT investigation

DT Investigation

This is an investigation into the accuracy of the WSPR and JT65 timing in the U3S. The conclusion is that the timing is very closely compliant with the relevant protocols.

Read more...